« previous next »
Pages: [1]   Go Down

Author Topic: (US) Need someone with calibrated VNA for a one-off  (Read 1850 times)

0 Members and 1 Guest are viewing this topic.

Offline jmwTopic starter

  • Frequent Contributor
  • **
  • Posts: 292
  • Country: us
(US) Need someone with calibrated VNA for a one-off
« on: September 19, 2020, 12:27:31 am »
I made my own set of OSL standards (https://www.eevblog.com/forum/rf-microwave/coefficients-in-diy-calibration-kit-for-vna/) based on off-the-shelf SMA connectors and FDTD simulation of their geometry, and I'd like to check my results. I need someone with a VNA and a real calibration kit to measure them, and send back the .s1p files. I need results from 2 MHz to 3 GHz but won't complain if you can go beyond. Prefer to work with someone in the US to keep shipping the parts to and fro easy.

Logged
 

Offline chrisl

  • Regular Contributor
  • *
  • Posts: 90
  • Country: us
Re: (US) Need someone with calibrated VNA for a one-off
« Reply #1 on: September 19, 2020, 09:58:34 pm »
I can help.  PM me for my address to send the kit.
Logged
 

Offline virtualparticles

  • Regular Contributor
  • *
  • Posts: 137
  • Country: us
Re: (US) Need someone with calibrated VNA for a one-off
« Reply #2 on: December 02, 2020, 10:46:35 pm »
I could help as well if you like. brian@walkerengineering.tech
Logged
 

Offline AllisonSharp

  • Newbie
  • Posts: 2
  • Country: us
Re: (US) Need someone with calibrated VNA for a one-off
« Reply #3 on: December 24, 2020, 04:07:49 pm »
Hi there,
Hope it is still relevant.
You can also send me in PM if you need any solution 8).
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee