Author Topic: Designer Needed - ESP32 Based IoT Project - Schematic & Board Layout  (Read 1332 times)

0 Members and 1 Guest are viewing this topic.

Offline drphil3dTopic starter

  • Newbie
  • Posts: 2
  • Country: us
I have a nearly complete schematic and rough idea of the board layout in Fusion 360 / Eagle. However am not an electrical engineer and lack the ability to finish this on my own. I'm looking for somebody that can pick up where I left off or work with me to complete the project. I've done a lot of the hard work of creating libraries and and component sourcing.

What it consists of:
ESP32
- power supervisor
- voltage regulators
TFT Display with resistive touchscreen
some buttons and rgb leds
GPS
DHT22
Li-ion charge controller
Load Cell Amplifier

I'm looking to hire on contract or hourly basis. There's likely around 20 to 30 hours of work required.
Let me know if you are interested, Thanks! ;D
 

Online tautech

  • Super Contributor
  • ***
  • Posts: 29923
  • Country: nz
  • Taupaki Technologies Ltd. Siglent Distributor NZ.
    • Taupaki Technologies Ltd.
Re: Designer Needed - ESP32 Based IoT Project - Schematic & Board Layout
« Reply #1 on: September 30, 2020, 04:52:15 am »
Member T3sl4co1l is probably the guy for you.
Avid Rabid Hobbyist.
Some stuff seen @ Siglent HQ cannot be shared.
 

Offline maxpayne

  • Regular Contributor
  • *
  • Posts: 140
Re: Designer Needed - ESP32 Based IoT Project - Schematic & Board Layout
« Reply #2 on: September 30, 2020, 05:44:50 am »
I will be happy to complete the project. I am a professional Layout Design Engineer and working with EAGLE for last 15 years.

Give me hollar if you are interested.

 

Offline radiokot

  • Contributor
  • Posts: 10
  • Country: ru
Re: Designer Needed - ESP32 Based IoT Project - Schematic & Board Layout
« Reply #3 on: October 01, 2020, 01:47:06 am »
Hi. I can develop, write me on the post shkoteikin@gmail.com
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf