San jose / bay area : hardware person wanted -full time-

[free_electron]

Make test jigs, characterise prototypes.
Perform measurements using scope, pc, multimeters , power supplies. And document procedures and results
Design circuits , power supplies, battery chargers,
Debug board level stuff and bringup of prototypes
Maintain parts stock and prepare assembly kits for the subcontractor
Order parts , keep track of stuff
Help the firmware guys during bringup of i2c , spi can and other busses when they can't get it to work : check wiring, signal levels, protocol etc.
Assemble and rework prototypes. 0201 0402 0603 and chip scale packages. Good manual dexterity and steady hand is required ( we have Mantis microscopes, reflow / hot air stations and very fine pitch soldering equipment. All you need is to bring a steady hand.

Bonus points
- familiar with ARM cortex / keil (board support / hal kind of work: de ugging low level code / driver code on arm)
- familiar with altium (schematic /board )
- familiar with low power design (designs running years from a coincell)

this is a full time job locate in the heart of San Jose. We have a VTA and bus stop literally at our door.

Essentially looking for a self starter / hobbyist that wants to learn and apply his skills.

[nctnico]

Just to be clear: Is this for Tesla or your other 'gig'?

[free_electron]

other gig. nothing to do with Tesla

[Icarus]

How about H1B ?

[Ryano]

Damn, I would be perfect for this position! If only it was about 850 miles to the north. 

[Richard Crowley]

You pretty much have to be already living in the Bay Area.  The job probably doesn't pay enough to move there and arrange new living quarters.  Unless you want to live in a cardboard box under a bridge or something.  I believe that area has the highest housing costs in the country (or close to it).

[ez24]

cardboard box under a bridge or something

  -->  $1000 a month

[linux-works]

(PM sent)