Author Topic: Convert pcb from gEDA to kicad format  (Read 998 times)

0 Members and 1 Guest are viewing this topic.

Offline sink

  • Contributor
  • Posts: 10
  • Country: pl
Convert pcb from gEDA to kicad format
« on: June 14, 2021, 11:03:36 pm »
Hi everyone,
Is there some plugin that will allow me to convert pcb designed in gEDA to kicad pcb project? I was looking for it for some time but I can't find it nowhere.

Thanks
SiNK
 

Offline Doctorandus_P

  • Super Contributor
  • ***
  • Posts: 1660
  • Country: nl
Re: Convert pcb from gEDA to kicad format
« Reply #1 on: June 19, 2021, 01:22:24 am »
Create a set of gerber files, then start Kicad and use its Gerbview to export them into a .pcb project.

A lot of information is missing from gerber files, but it's a lot better then nothing.
With this method you get:

* PCB outline & locations of mounting holes.
* All copper tracks.
* Footprint locations (you can place new footprints on the ends of the existing tracks).
* Netlist (This is implicitly created when you put new footprints on the existing tracks).

You have to manually re-create the schematic (And footprint association). I once did this for a test and I made a few mistakes in the re-creation of the schematic, and those were caught because the schematic did not match up with the PCB, and DRC in Pcbnew told me where the errors were.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf