« previous next »
Pages: [1]   Go Down

Author Topic: Chemtronic flux-off spray brush is ESD safe?  (Read 839 times)

0 Members and 1 Guest are viewing this topic.

Offline FaringdonTopic starter

  • Super Contributor
  • ***
  • Posts: 1991
  • Country: gb
Chemtronic flux-off spray brush is ESD safe?
« on: July 07, 2021, 11:44:16 am »
Hi
This Chemtronix “Flux-off” spray has a brush on its nozzle….do you think its ESD non-generative to brush over components after spraying them with the “flux-off”?

Chemtronix “Flux-off”
http://www.farnell.com/datasheets/2692996.pdf

Logged
'Perfection' is the enemy of 'perfectly satisfactory'
 

Offline thm_w

  • Super Contributor
  • ***
  • Posts: 6378
  • Country: ca
  • Non-expert
Re: Chemtronic flux-off spray brush is ESD safe?
« Reply #1 on: July 07, 2021, 09:14:13 pm »
Visually it does look like it: https://tmelectronics.ru/product/CH-ES830BE/ but they don't tell you.

If you are working on something super sensitive to ESD I would get a proper esd safe brush and then add a wrist strap. For normal electronics that thing will be fine.
Logged
Profile -> Modify profile -> Look and Layout ->  Don't show users' signatures
 
The following users thanked this post: Faringdon

Offline FaringdonTopic starter

  • Super Contributor
  • ***
  • Posts: 1991
  • Country: gb
Re: Chemtronic flux-off spray brush is ESD safe?
« Reply #2 on: July 08, 2021, 06:06:41 am »
Thanks i just brushed over a 12MSOP pwm controller IC with it...i hope it will be OK
Logged
'Perfection' is the enemy of 'perfectly satisfactory'
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee