Author Topic: Gerbv not slowing slots  (Read 2662 times)

0 Members and 2 Guests are viewing this topic.

Offline Dagon

  • Regular Contributor
  • *
  • Posts: 61
  • Country: ie
Gerbv not slowing slots
« on: June 15, 2012, 05:04:02 pm »
I normally use Gerbv to check my gerbers before sending them off. However I haven't had boards with any slots before and it's just showing them as normal holes.

Diptrace's export preview and kicads gerber viewer show them just fine so I assume it's a Gerbv thing but I thought I'd check on the off chance there's something whacky about the drill file. Anybody know if Gerbv should handle slots?


I saw Elvis. He sat between me and bigfoot on the UFO.
 

Offline Short Circuit

  • Frequent Contributor
  • **
  • Posts: 439
  • Country: nl
Re: Gerbv not slowing slots
« Reply #1 on: June 15, 2012, 05:09:23 pm »
ViewMasterEZ shows the three slots, so the NC file seems fine.
 

Offline Dagon

  • Regular Contributor
  • *
  • Posts: 61
  • Country: ie
Re: Gerbv not slowing slots
« Reply #2 on: June 15, 2012, 05:21:10 pm »
Yeah, thought it might have just been Gerbv, thanks for checking.
I saw Elvis. He sat between me and bigfoot on the UFO.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf