Electronics > Manufacturing & Assembly

Gerbv not slowing slots

(1/1)

Dagon:
I normally use Gerbv to check my gerbers before sending them off. However I haven't had boards with any slots before and it's just showing them as normal holes.

Diptrace's export preview and kicads gerber viewer show them just fine so I assume it's a Gerbv thing but I thought I'd check on the off chance there's something whacky about the drill file. Anybody know if Gerbv should handle slots?


Short Circuit:
ViewMasterEZ shows the three slots, so the NC file seems fine.

Dagon:
Yeah, thought it might have just been Gerbv, thanks for checking.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version