Electronics > Manufacturing & Assembly
How thick is via plating ?
Simon:
Well i have put in via's with 1.5mm holes so I can easily solder a wire through.
EEVblog:
--- Quote from: free_electron on October 30, 2013, 11:55:34 pm ---
--- Quote from: kayvee on October 30, 2013, 12:38:24 pm ---If you make the vias larger and leave them untented you can always let the wave solder process fill them with solder making a nice low resistance path, or if you are hand soldering the boards, manually fill the untented vias up with solder afterwards.
--- End quote ---
that doesn't do anything
--- End quote ---
It will, just not a huge amount. Similar to what Mike and I measured in our testing of solder coated tracks.
EEVblog:
I've just created this chart for current capacity
Simon:
Thanks Dave, seems 1.5mm is on the right track and I'll solder a wire through for good measure
Navigation
[0] Message Index
[*] Previous page
Go to full version