| Electronics > Manufacturing & Assembly |
| Looking for a PCB House |
| (1/2) > >> |
| andersendr:
Hello Guys, I like the boards Dave gets made and I think I can remember that he has mentioned his board house before. Does anyone know what he uses? I am trying to stay away from ITead from the few mess ups I have seen from people. I am looking for a place that will gold plate it. I have not found of a lot of houses doing this. I would like the gold platting for the high speed connectors in a not so clean environment. |
| joelby:
I've personally had no trouble at all with ITead, and you really can't go wrong for the price. PCBCart.com will do gold fingers and gold finishes, and I can recommend them highly for any board with requirements outside of Seeed, ITead, or DorkbotPDX's parameters. |
| andersendr:
Thanks Joelby. I may give ITead a try. The other problem is I don't need 10 boards, but for the price I'll just toss the other ones on the shelf. I'll have a look at the other companies you listed and see if they meet my req's. |
| joelby:
Exactly. For a delivered price of under $20, you can afford to throw most of them away. If there genuinely are manufacturing problems with your boards, they'll probably replace them. You might even consider doing a few prototype spins through a lower cost provider. Once you're happy that the design is correct, get a more expensive PCB house to do one with gold. |
| Psi:
www.ourpcb.com are also quite good. But im pretty sure ITead will be cheaper for only a few boards. |
| Navigation |
| Message Index |
| Next page |