Electronics > Manufacturing & Assembly

Looking for a PCB House

(1/2) > >>

andersendr:
Hello Guys, I like the boards Dave gets made and I think I can remember that he has mentioned his board house before.  Does anyone know what he uses?  I am trying to stay away from ITead from the few mess ups I have seen from people.  I am looking for a place that will gold plate it.  I have not found of a lot of houses doing this.  I would like the gold platting for the high speed connectors in a not so clean environment. 

joelby:
I've personally had no trouble at all with ITead, and you really can't go wrong for the price.

PCBCart.com will do gold fingers and gold finishes, and I can recommend them highly for any board with requirements outside of Seeed, ITead, or DorkbotPDX's parameters.

andersendr:
Thanks Joelby.  I may give ITead a try.  The other problem is I don't need 10 boards, but for the price I'll just toss the other ones on the shelf.  I'll have a look at the other companies you listed and see if they meet my req's.

joelby:
Exactly. For a delivered price of under $20, you can afford to throw most of them away. If there genuinely are manufacturing problems with your boards, they'll probably replace them.

You might even consider doing a few prototype spins through a lower cost provider. Once you're happy that the design is correct, get a more expensive PCB house to do one with gold.

Psi:
www.ourpcb.com are also quite good.
But im pretty sure ITead will be cheaper for only a few boards.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version