Electronics > Manufacturing & Assembly

Opinions: Is this a marketable product? Manual SMD feeders.

<< < (3/3)

Rat_Patrol:
Maybe its my OCD, but dumping parts in a try drives me nuts! And then I have to run each part at at time. My current work flow for manual placement is to paste the board, I have a simple elevated hand platform 3D printed out, then start at the top and work my way down.

alexaraujo:

--- Quote from: Mangozac on October 17, 2021, 11:50:36 pm ---
--- Quote from: jduncan on October 15, 2021, 09:22:54 pm ---Seems like a solution looking for problem to me. Never had an issue dumping my parts from tape into a tray.

There's a ton of 3d-printed low end feeds on hackaday/thingiverse already.

--- End quote ---
I'm inclined to agree. Larger parts can just be dumped into a tray. This seems like a great solution for 8mm tapes: https://www.thingiverse.com/thing:3952021

--- End quote ---

I have 15 piece, it's good and practical.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version