Electronics > Manufacturing & Assembly

Recommended PCB assembler

(1/2) > >>

Pedro147:
I am after some advice as to how to go about having some 27mm x 32mm PCB,s populated with parts that I will supply here in Australia, Canberra if possible  :) unlikely I know.  Mainly SMD passives - 0603 and 0805, 1.25mm, 1.5mm and 2mm sockets, IRLML6244 mosfets, QFN-44 (ATMEGA32U4-MUR), 3mm x 3mm QFN TPS6300 and a 16-pin LGA package ICM-20608-G gyro. I apologise if I am asking this question in an unconventional manner but this is well out of my normal sphere of experience. I have heard Dave Jones mention about having some boards assembled here in Australia. It would only be initially a few boards just to test prior to a larger batch being populated by machine. Thanks for reading and hopefully offering some advice Pedro.
 

crispy_tofu:
The EEVBlog Wiki has a list of PCB Assemblers:
http://www.eevblog.com/wiki/index.php?title=PCB_Assemblers
It's a bit outdated though...
Looking on Google, it doesn't seem that there are any assemblers in Canberra, but there are a few in Sydney (e.g. https://puzzleprecision.com.au/ , who specialise in SMD, I have no affiliation with them).
Hope this helps!  ;D

Korken:
I use PCBCart and Macrofab, both do good work (at this size).

slowertech:
I really like MacroFab but they are based in Texas.

Pedro147:
Sorry to all of you that replied, but I did not have email notifications set in my preferences and only just came back to the forum today. Thanks for all the suggestions

Peter

Navigation

[0] Message Index

[#] Next page