Electronics > Manufacturing & Assembly

Reflow oven for home use

<< < (7/7)

tggzzz:

--- Quote from: DerekG on June 06, 2015, 10:04:21 pm ---
--- Quote from: tggzzz on June 06, 2015, 05:46:51 pm ---At least with a saucepan+sand the heating is even and traverses a uniform thickness (1.6mm) before getting to the solder paste.

--- End quote ---

I wonder if it would be worth placing a sheet of alfoil on top of the sand? This would keep the sand from touching the bottom side of the board.

--- End quote ---

Possibly, but it might introduce other effects. It would reduce the probability of a few grains of sand getting onto the top/component side of the board. They can be brushjed off and don't cause any problem, but it is fundamentally inelegant.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod