Electronics > Manufacturing & Assembly

SMD and shaky hands - please help.

<< < (6/6)

doppelgrau:
If you have a unused 3d printer, you might try to convert it to a simple PNP with OpenPnP and "LoosePartFeeders" (or HeapFeeder) for passives and strip Feeder for rest.

Brage:
I had that machine at my old work. Highly recommend it if you can afford it.
Don't need all the bells and whistles, though. Ours had most of the stuff shown in the video, except the flipper. Did not really use any of it other than the placement arm itself. A piece of sticky-tape to stick down the components, some good lighting, and taking it slowly.

A more budget solution, like the videos shown, might do the same job. I'd get a good mechanism for rotating (yaw, about the z-axis) the components after you have picked them up.

tooki:

--- Quote from: Gyro on January 24, 2022, 09:15:08 pm ---What are you using for magnification? I have shaky hands but find that the shaking decreases significantly when using my binocular microscope.

--- End quote ---
This. I cannot emphasize enough how much of a difference it makes.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version