Electronics > Manufacturing & Assembly

SMTech Stencil Printer (Quad branded)

(1/1)

gmr1981:
Hi,

I have recently acquired an SMTech stencil printer from 1996. It is mechanically sound, but the main control PCB seems to have some problems (I suspect the data on the microprocessor/eeprom) - a lot of the functionality works but when I go into some menus the program just crashes and I can't get as far as printing. Also, sometimes it doesn't boot up properly.

Anyone got any experience of these machines?

Cheers,
Greg

gmr1981:
Answering my own question: I found Reprint International in Dorset who offer support for these machines and were very helpful.

Navigation

[0] Message Index