Electronics > Manufacturing & Assembly

HWGC P&P machines - Documentation, Discussion and Info

<< < (43/60) > >>

alexaraujo:

--- Quote from: Jackster on December 14, 2021, 02:33:20 pm ---
--- Quote from: alexaraujo on December 14, 2021, 02:04:07 pm ---I'm really excited. My anxiety part keeps telling me to turn on the machine right away, the other part of my methodical part is checking everything, and everything else.

Today I did a free translation of the machine maintenance chapter into Portuguese. But I found it very incomplete. So our friends from this more experienced forum can contribute with preventive maintenance tips for PnP machine I will be grateful.

Later today I will take more pictures of the equipment.

About the oven: I chose one of six zones with 2600mm.

Below are parts of the maintenance manual

--- End quote ---

I would be happy to create an online wiki so everyone can collaborate on this sort of thing if others are interested?
Need to set up a wiki for one of my products so will give me an excuse to work out the best way to do it.

--- End quote ---

For me is perfect.I help on the wiki

Jackster:

--- Quote from: alexaraujo on December 14, 2021, 11:26:06 pm ---For me is perfect.I help on the wiki

--- End quote ---

Started working on it here, https://hwgc.jogara.co.uk/ (temp domain)

alexaraujo:
Below is a photo of the oven more closely and the first manufacturing project.

Thank you very much for our friend's videos
48X24X48X, the videos posted are helping me a lot. Tomorrow I must run the first print run of plates.

alexaraujo:

--- Quote from: Jackster on December 14, 2021, 11:27:30 pm ---
--- Quote from: alexaraujo on December 14, 2021, 11:26:06 pm ---For me is perfect.I help on the wiki

--- End quote ---

Started working on it here, https://hwgc.jogara.co.uk/ (temp domain)

--- End quote ---
.

my topic suggestion for wiki

1) Prerequisites
2) Installation
3) First Steps
4) Configuration of PCB files
5) Setting up PCB panel.
6) Feeder configuration.
7) Production setup.
8) Setting up footprint
9) Calibration
10) Fault handling.
11) Cautions when updating
12) Corrective and preventive maintenance.

Jackster:

--- Quote from: alexaraujo on December 14, 2021, 11:51:58 pm ---
--- Quote from: Jackster on December 14, 2021, 11:27:30 pm ---
--- Quote from: alexaraujo on December 14, 2021, 11:26:06 pm ---For me is perfect.I help on the wiki

--- End quote ---

Started working on it here, https://hwgc.jogara.co.uk/ (temp domain)

--- End quote ---
.

my topic suggestion for wiki

1) Prerequisites
2) Installation
3) First Steps
4) Configuration of PCB files
5) Setting up PCB panel.
6) Feeder configuration.
7) Production setup.
8) Setting up footprint
9) Calibration
10) Fault handling.
11) Cautions when updating
12) Corrective and preventive maintenance.

--- End quote ---

I have started to fill out what I can though I don't have access to the machine so what I can do is limited.
https://hwgc.jogara.co.uk/en/software

Feel free to register and ping me a DM with your username. I will enable your account to add content.
Let me know what language to enable. Currently, there is English and Portuguese (Brazil).

To not fill this thread with loads of wiki talk, I have set up a Discord, https://discord.gg/xN8HmN9Tea

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version