Electronics > Mechanical & Automation Engineering
2-56 and other small screw cutters or compatible tool for modification
jpanhalt:
--- Quote from: coppercone2 on April 06, 2024, 01:43:23 pm ---If I could get a trained squirrel to work with tiny nuts I would but I can't. I hate working with that BS. Hand tools should be big.
--- End quote ---
See solution offered by memdip_discovery. Why did you bother asking? Just switch to 1/8" hardware and scale everything else up.
Navigation
[0] Message Index
[*] Previous page
Go to full version