Electronics > Mechanical & Automation Engineering
af8 crimp tool tightening?
coppercone2:
works great, be careful inserting strands. No-nogo gauge reassured me. 4 fails in a row.. bad day
coppercone2:
bought the go-nogo gauge so I don't waste peoples time with crimp troubleshooting
coppercone2:
go/no go gauge seems to say the tool is fine. Must have been some user error.. better work under a well lit magnifier this time
No one has seen a crimp tool that passes gauge test but still does not crimp have they?
coppercone2:
ok, it worked. I guess I must have kept losing wire strands during insertion.
So it seems that its a good tool after all.. just gotta be REALLY careful. Don't know how I managed to screw up 4 crimps in a row.......
with solder and large connectors it hardly matters if you lose a strand, with this thing you gotta be real good.
Kjelt:
I now also own this tool the af8 and the afm8.
Did you use the correct setting, brand connector and belonging turret?
I never had a failed crimp yet (done 40+)
The tool it self costs $400+ which is reasonable if you take into account that the 1:1 copies from China will set you back over $200.
But why do they sell hundreds of turrets (one for every connector type) each costing over $150 ? I mean the only thing it does is holding the barrel centralized and in the right distance for the crimp.
Navigation
[0] Message Index
[#] Next page
Go to full version