Electronics > Mechanical & Automation Engineering

Backward stabilization of a Z-axis (with image)

<< < (3/3)

Overspeed:
Hello

As your frame with be fit on a 30x60 extruded rail , your total stiffness will far higher that the drawing you have displayed in the first post

For Plywood the problem is the surface compression and dont forget than a wood is not another , some plywood fully injected of resin as the plywood use for concrete mold ( black plywood ) are acceptable for a lot of DIY project .

Remember that some WWII airplane was made partially in plywood as the Horten 229 and the DH 98 Mosquito was built in wood

Regards
OS

Navigation

[0] Message Index

[*] Previous page