Electronics > Mechanical & Automation Engineering

Best tool for cutting off a plastic-flange chunk from inside an enclosure?

<< < (6/6)

Doctorandus_P:
Also, things like a dremel (like) or hot knife are not very expensive. If you go in the direction of a custom jig for this, the put in (an option) for two of those devices so you can cut both tabs at the same time.

coppercone2:
if you make a jig put a vacuum cleaner attachment in there too

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod