Electronics > Mechanical & Automation Engineering

CNC3018 Grbl Offline Controller Ali Firmware

(1/4) > >>

jemp:
Hello, I have an offline controller for a CNC3018 Arduino Woodpecker Board, shown in pictures (source internet)
Buy playing with the firmware, I managed to brick it
Unfortunately my backup of the original firmware is lost
Does anybody has this firmware or wants to read it out
It is a STM32F103RBT6 MCU on board and can be read with STLlink v2 with the SW connections
the order is +5V, SDClck, SDIO, GND, and setting is slow speed 480khz
Tnx 4 help
JP

Doctorandus_P:

--- Quote from: jemp on November 14, 2021, 10:49:58 am ---It is a STM32F103RBT6

--- End quote ---

No it is not.
It is an APM32F103RBT6

The APM is mostly compatible with the STM but there are differences.

A quick search for "arduino woodpecker" gives lots of results relating to GRBL and apparently there are some versions of GRBL floating around that work for that hardware.

jemp:
Tnx DP, for answer, but does it help me ?
off course not... just corrections...
What I need is firmware and some helpfull tips or someone can read it , with an SWD programmer
And look at the attached picture.. what shoud it be ?
it is the old version from 2018 and not the new

Tnx for any helpfull messages.

MickyNuts:
HI Guy.

I have this board and luckily I also had a stlink.
I therefore made a backup (stock unmodified) for you with the software. please excuse me but it is without guarantee because I had never used such software.
I just came across your message and wanted to help you.
I hope it's not too late. My offline board was delivered with the CNC3018 PRO (ALIEXPRESS with the JLF001 motherboard) it had GRBL0.9j (having updated to GRBL 1.1F, the controller no longer works with it for some unknown reason) if you must also have the JLF001 dump file with GRBL0.9j, leave me a message, I have already performed the dumps.
Sorry english translated i am swiss speaking french. To the pleasure. If the file is not correct. tell me how to do it right.
Mickynuts

jemp:
Tnx Micky

Will test it..

Je vais le tester, et si tout est bien, je vous confirme :-)

Tnx / Merci

JP ( je parle les 4 ;-)

Navigation

[0] Message Index

[#] Next page