Electronics > Mechanical & Automation Engineering

CNC3018 Grbl Offline Controller Ali Firmware

(1/1)

jemp:
Hello, I have an offline controller for a CNC3018 Arduino Woodpecker Board, shown in pictures (source internet)
Buy playing with the firmware, I managed to brick it
Unfortunately my backup of the original firmware is lost
Does anybody has this firmware or wants to read it out
It is a STM32F103RBT6 MCU on board and can be read with STLlink v2 with the SW connections
the order is +5V, SDClck, SDIO, GND, and setting is slow speed 480khz
Tnx 4 help
JP

Doctorandus_P:

--- Quote from: jemp on November 14, 2021, 10:49:58 am ---It is a STM32F103RBT6

--- End quote ---

No it is not.
It is an APM32F103RBT6

The APM is mostly compatible with the STM but there are differences.

A quick search for "arduino woodpecker" gives lots of results relating to GRBL and apparently there are some versions of GRBL floating around that work for that hardware.

jemp:
Tnx DP, for answer, but does it help me ?
off course not... just corrections...
What I need is firmware and some helpfull tips or someone can read it , with an SWD programmer
And look at the attached picture.. what shoud it be ?
it is the old version from 2018 and not the new

Tnx for any helpfull messages.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version