Off Topic Hobbies > Mechanical Engineering

Help With 3D Model

<< < (2/2)

beanflying:
Doesn't maybe matter for this one if you are comfortable with a solution from above but it sort of keeps E and M a bit separate. Down the bottom left as per below anyway is how to move your own topics as per the attachment.

bostonman:
I accidentally asked this question in the wrong section and moved it here.

All I'm trying to do is push/pull at an angle but I can't figure out how. Can anyone help?

beanflying:
Had a quick search for getting sketchup to do this and this ugly approach turned up https://designerhacks.com/how-to-make-an-angled-cut-in-sketchup-sketchup-q-a/

So using this create your extrusion holder as square stock, then cut the bottom at an angle of X, rotate that cut part back flat to an origin plane, then stick it onto a base bit. Horrible workflow but it should get it done.

Infraviolet:
If you're still after Sketchup help I've used it before and might be able to answer some questions.

bostonman:
That link didn't work.


--- Quote ---If you're still after Sketchup help I've used it before and might be able to answer some questions.
--- End quote ---


Take a look at the .zip file I included in my initial post and the question I had.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version