Electronics > Mechanical & Automation Engineering

runout question

(1/4) > >>

vivi-d:
This machine specifies its max runout is 0.05mm or about 2 mils. Could this mill 8 mil traces reliably?

https://www.nymolabs.com/products/nymolabs-6040-cnc-router-machine

Smokey:
That machine doesn't look very rigid. 
Why not just get same week actual professional PCBs from JLCPCB/pcbway/etc? For $1800 you can afford the 2Day turn :)

vivi-d:
I could but that is not as fun. How can you tell it is not ridged?

Smokey:

--- Quote from: vivi-d on January 08, 2025, 09:20:39 pm ---I could but that is not as fun. How can you tell it is not ridged?

--- End quote ---

Because it doesn't look like this :)
https://www.instagram.com/cnctechnikmueller/p/DDFDh_Jq4c-/?img_index=1

thm_w:

--- Quote from: vivi-d on January 08, 2025, 09:20:39 pm ---I could but that is not as fun. How can you tell it is not ridged?

--- End quote ---

It will go from "fun" to tedious and annoying by the first or second board. Don't waste your money.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod