Electronics > Mechanical & Automation Engineering
Searching for a simple way to use AS-interface
(1/1)
printplaatreparatie.nl:
Hi there, I got hold of some Eaton Rapid Link 4.0 Frequency controllers and motor starters. I would like to use them in a to-be-determined project, but I have no idea how to use the AS-interface in a simple way, without spending a lot of money and leaning to program a PLC.
I found this raspberry pi board: https://tinyurl.com/tv4g356 but found no information how to use it.
Ideally, I would like to use an (industrial) Arduino or simular open-source device to get those units to behave.
Can anyone shine some light over the black box of AS-interface? All I can find is how amazing it is (for machine builders with a nice budget.)
rvalente:
Do you really have to use ASI?
For me, was a network that although has been used, never saw much of a commercial success nor interest to be maintained by users.
If you wanna learn about ASI try to find some used modbus 485/ethernet to asi interfaces.
If you can get away without it, do, go for modbus or canopen
Navigation
[0] Message Index
Go to full version