Electronics > Mechanical Engineering

Used Precision Lathe machine

(1/11) > >>

xzswq21:
Hello
I want to buy a used small and Precision lathe machine, the accuracy (Backlash) should be better than 0.05mm, I usually work on small size Teflon/Brass/Steel rods for the instrumentation industry. (Cutting, boring, making internal and external thread)

I would like a lathe machine similar to WABECO D2000, PROXXON PD 400, KLIPPFELD and etc

if you have one please let me know,

Thanks

xzswq21:
what do you think about "Grizzly" lathe machines? is it an American company?

fcb:
What country are you in? It would help if you changed your profile to reflect this.

If you want a precision small lathe, then I'd hunt out a used Schaublin (65/70/102) depending on needs. Wabeco, Poxxxxxxon etc. are not precision..

BradC:

--- Quote from: xzswq21 on August 25, 2021, 10:44:26 am ---the accuracy should be better than 0.05mm, I usually work on small size Teflon/Brass/Steel rods for the industry.
--- End quote ---

That's almost 2 thou. You should be able to do that on pretty much any reasonably set up machine.

xzswq21:

--- Quote from: fcb on August 25, 2021, 02:07:19 pm ---What country are you in? It would help if you changed your profile to reflect this.

If you want a precision small lathe, then I'd hunt out a used Schaublin (65/70/102) depending on needs. Wabeco, Poxxxxxxon etc. are not precision..

--- End quote ---

I've found several Schaublin lathe on eBay but they are very old,

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version