Author Topic: Video guide for LKPF PROTOMAT C30 PCB milling machine  (Read 5634 times)

0 Members and 1 Guest are viewing this topic.

Offline FaringdonTopic starter

  • Super Contributor
  • ***
  • Posts: 1973
  • Country: gb
Video guide for LKPF PROTOMAT C30 PCB milling machine
« on: July 26, 2023, 07:01:11 pm »
Hi,
Does anyone have an English guide video for use of the above milling machine to  make PCBs with?...to use the software with the milling machine?
ie, to mill out a single sided PCB from a single sided  copper cladded board.

« Last Edit: July 26, 2023, 07:03:47 pm by Faringdon »
'Perfection' is the enemy of 'perfectly satisfactory'
 

Offline jpanhalt

  • Super Contributor
  • ***
  • Posts: 3451
  • Country: us
Re: Video guide for LKPF PROTOMAT C30 PCB milling machine
« Reply #1 on: July 28, 2023, 08:25:05 pm »
1) The copper thickness on a PCB (1 oz) is quite thin.  So, it needs to be very flat or at least its surface needs to mapped.
2) In your other thread, you stated that a 5-day TAT from JLCPBB was too long.  When will your inferior, milled PCB be done?
 
The following users thanked this post: David Aurora, Faringdon


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf