Author Topic: Calibrating 53132A (Read 15409 times)

nikonoid · « **Reply #50 on:** September 27, 2019, 05:30:11 am »

Same here as well. Thank you.

BTW, can you simulate the 59992a output with dual output signal generator?

TheSteve · « **Reply #51 on:** September 27, 2019, 05:45:19 am »

I used a dual output gen to do that stage of the the cal, but can't verify if it was better or not. It did pass fine though.

nikonoid · « **Reply #52 on:** September 27, 2019, 10:18:06 pm »

Good to know, Steve. Thanks.

What settings did you use for modes 1 through 4?

VK4VVK · « **Reply #53 on:** March 03, 2024, 10:27:08 am »

Hi mate, just wondering if the calibration kit is still available?
Thanks.

EEVblog Electronics Community Forum