Electronics > Metrology

Consult: May I ask 6L board can be changed to 4L board?

(1/2) > >>

nail10:
I take into account the original 6L is hit by the blind hole, to change 4L after the full to change through the hole?

Rerouter:
Your going to have to better explain your question

PA0PBZ:
My guess: It's about PCB's

> Can you change a 6 layer board to a 4 layer board?  It depends.

And then something about blind vias.

Not metrology at all.

nail10:
I don't know how to put the circuit board six blind into four layers through hole


--- Quote from: Rerouter on June 30, 2016, 08:28:34 am ---Your going to have to better explain your question

--- End quote ---

nail10:
Sorry, i am new member,not very understanding of this forum


--- Quote from: DiligentMinds.com on June 30, 2016, 05:11:26 pm ---There is another sub-forum for PCB stuff.  This is not metrology related, please take your questions to the right place.

Try here:  https://www.eevblog.com/forum/eda

--- End quote ---

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks WYSIWYG Editor
Powered by SMFPacks Advanced Attachments Uploader Mod