Electronics > Metrology

DIY Low EMF cable and connectors

(1/50) > >>

quarks:
Hello all,

for quite some time, I am experimenting with Low EMF connections/cables. I have different things allready tested and found this crimp spade lugs from AMP (see picture) to be very good. Unfortunately I cannot find it on-line. Does anyone know the partnumber of it or a place where I can find it?

thx
quarks

grenert:
Sorry, can't help you with that particular part, but I see that Mouser carries Pomona low EMF lugs with banana plug inserts:
http://www.mouser.com/Search/ProductDetail.aspx?qs=LxJU1xRJL0GNFHRHCmLa5A%3D%3D

quarks:

--- Quote from: grenert on February 09, 2013, 06:56:19 pm ---Sorry, can't help you with that particular part, but I see that Mouser carries Pomona low EMF lugs with banana plug inserts:
http://www.mouser.com/Search/ProductDetail.aspx?qs=LxJU1xRJL0GNFHRHCmLa5A%3D%3D

--- End quote ---
Thx a lot grenert,
I know the Pomona low emf parts and it is good to know where to get them outside of the USA.
For my actual DIY low emf experiments I look especially for crimp spade lugs pure copper (pref. Gold plated and/or with tellur) with low thermal mass (for fast equilibrium; I hope that is the right word).
All the parts I found and tried are either heavy Audio versions or tinned copper versions.
The above showed AMP is so far the best match to what I want.

quarks:
Is there anyone else, interested in this topic?
If yes, I will keep on asking and posting. 

So far I found this article very good "Metrology 101 - Watch out for those Thermoelectric Voltages!" (see link)

http://us.flukecal.com/literature/electrical-calibration/watch-out-those-thermoelectric-voltages-cal-lab-journal-reprint

If anyone has more useful ideas, how to do more tests, please share.

With grenerts good hint, I ordered at mouser some Pomona Low EMF stuff.
I made already quite a few comparisons and will keep on testing.

PS: Still hope to get a hint for the AMP spade lug or something similar!

robrenz:
http://www.testpath.com/Categories/Low-Thermal-EMF-Patch-Cords-1410.htm?ctl00_MainContent_Results_ProductListChangePage=1

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version