Electronics > Metrology

Extenders for the Datron 4800 series of calibrators?

(1/3) > >>

perdrix:
Are you interested in purchasing extenders for a Datron 4800 series calibrator?   If so I'm considering getting some made up.

Price will depend on how much interest and they won't be small PCBs.  By way of guidance, back in 2011 I had 25 extenders of a similar size to the large boards made and the unit cost was USD28.
 
Let me know if you are interested.

Cheers
Dave

ap:
Great, I would buy some. How do you plan to cover the different ones?

CalMachine:
I would be interested in some PCB extender boards.   :-+

perdrix:

--- Quote from: ap on July 18, 2017, 06:22:08 pm ---Great, I would buy some. How do you plan to cover the different ones?

--- End quote ---

Argh! Are you saying that each board in a 4808 requires a different extender?  That's a rather unusual approach to say the least.

I've not looked this in detail yet, so I thought I'd only need two extenders, one for the large boards, and one for the small socketed PCB.

Dave

ap:
I have never opened up my 4808 (will soon have to for the battery replacement) but I remember having seen a backplane and that had connectors spead all over the place. What seems to be possible though from what I saw is to build a generic adapter for each specific connector type/width and then just combine them in a certain slot that is being worked on. Thats maybe the way to go.

Navigation

[0] Message Index

[#] Next page