Electronics > Metrology

Fluke application note about DMM test / calibration

(1/1)

Dr. Frank:
Fluke just has sent me a nice application note: "A generic DMM test and calibration strategy".

It can be found here: http://us.flukecal.com/node/19698

This AN describes the basic building blocks of a DMM, and how to verify its performance.

I used such a procedure, to evaluate the 34465A/470A, and to identify the errors of the 100V/1kV DCV ranges.

https://www.eevblog.com/forum/testgear/keysight's-new-34465a-(6-5-digit)-and-34470a-(7-5-digit)-bench-multimeters/msg889215/#msg889215

Frank

Mickle T.:
Ain't the same?

Dr. Frank:
Recycled, obviously, as Fluke recycles many DMM stuff from Wavetek / Datron.

Frank

enut11:

--- Quote from: Dr. Frank on May 31, 2016, 03:03:05 pm ---Recycled, obviously, as Fluke recycles many DMM stuff from Wavetek / Datron.

Frank

--- End quote ---

Thanks for sharing. It was a good bedtime read...

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version