Electronics > Metrology
K71-7 precision capacitor
shodan@micron:
void
bsw_m:
In fact, these capacitors actually have very good accuracy and low Df and Da.
I am sorry, I could not find my data on the measurement of dielectric absorption (it was a long time ago). But I remember exactly that the dielectric absorption of these capacitors was low. Measuring again is a lengthy process and requires preparation. But I measured the capacitance and Df. I measured 2 randomly taken samples with a nominal value of 470nF 5% tolerance and 100nF 0.5% tolerance. Measurement frequency was 1000Hz.
bob91343:
I don't consider 0.5% tolerance high precision. But it's a relative term. I think these could be considered general purpose, although they are better than most.
bob91343:
You can't fight over opinions. Since precision is a general term, each of us interprets it differently. I think 0.1% is precision. Those would be expensive lab standards but I think that gets into the realm of precision.
bdunham7:
Whatever they use in these...
https://www.chinakaip.com/products/detail/ch-17t-precision-standard-capacitance-box.html
Navigation
[0] Message Index
[#] Next page
Go to full version