Electronics > Metrology

Spread sheet aided calculation for standard resistor measurement

<< < (4/4)


--- Quote from: dacman on June 22, 2016, 09:37:13 pm ---Addition and subtraction only work because the standard is close to nominal.  If the standard had an offset of, for example, -900 ppm, then there would be an error of about 1 ppm in the result when compared to multiplying and dividing.

--- End quote ---
Correct. But if a standard has that kind of deviation as -900ppm, the tester probably won't care about 1ppm in the first place.


[0] Message Index

[*] Previous page

There was an error while thanking
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod