Electronics > Metrology

Where calibrating NOS Agilent 34401A

(1/5) > >>

pe1oxp:
I recently acquired a NOS Agilent 34401A produced in 2014, from a large batch also mentioned in another thread on this website.

Unfortunately there was no Certificate of Calibration included in the box, so I like to get a fresh calibration. The old certificate isn't found anymore on the Keysight website.

Any ideas about calibration centers who also deal with private persons and capable of calibrating 6.5 digit multimeters? Preferrable mainland Europe. In the past I used Keysight Netherlands for calibrating DMM's and for calibrating RF Power meters and sensors a center in the UK, but I don't know if there are any problems after Brexit.

Neganur:
Surely, Keysight Germany/Böblingen can cal 6.5 digit DMMs
US website lists some 300USD for the most basic cal so the EUR price should be similar, maybe some other place is cheaper.

voltsandjolts:
I get good service from Trescal UK, they are in NL, YMMV

https://www2.trescal.nl/en/

Overspeed:

--- Quote from: voltsandjolts on January 15, 2025, 09:24:53 pm ---I get good service from Trescal UK, they are in NL, YMMV

https://www2.trescal.nl/en/

--- End quote ---

Hello

Trescal can do that . No need to send back to Agilent .  Trescal is in France too .

Regards
OS

pe1oxp:

--- Quote from: Neganur on January 15, 2025, 09:14:38 pm ---Surely, Keysight Germany/Böblingen can cal 6.5 digit DMMs
US website lists some 300USD for the most basic cal so the EUR price should be similar, maybe some other place is cheaper.

--- End quote ---

Unfortunately Keysight doesn't deal with private persons anymore. In the past there was a special deal for about 175EUR but all prizes are rising

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod