Electronics > Metrology

Which used calibrator to put the hands on?

<< < (6/6)

ArthurDent:
Reading all this reminded me I have a COHU 355 standard that I've been planning to repair for a few years and I'm now inspired to check out the problem. It was working fine then just stopped so I don't think it is a major problem. Here are the specs on the unit which are a little hard to find. I have the manual so I have a chance of finding the problem.

Solodolo47:
Hello would you be able to send me a copy of the manual? I have just acquired a 355 and I have half of the manual. I really need the calibration portion of the manual.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod