Electronics > Microcontrollers

Interfacing to the parallel bus output of an ADC (AD7771) with a microcontroller

<< < (8/8)

So i ended up moving to a 2 board solution. I'm (planning on) using a SAMD51 which has a SD host controller (SDHC) and a PCC interface (for the ADC).  I'm considerably more well-versed in the samd21 and 51 then the SAM E70/V7x, however if this doesn't give me the performance i need ill end up making the switch. The chip was also physically smaller. I've never used DMA or PCC, so this will be "interesting".


[0] Message Index

[*] Previous page

There was an error while thanking
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod