the yellow LED is irrelevant, The only thing that matters is that there is no activity on the green and red LEDs.
What section are you OK and what section are you KO? Both together with "No response from target..."
Have you verified that your ttl adapter works? is it plugged in to the right port on the STorm32(some versions have swapped header locations)
For SWD bootloader mode, you need to find the "Boot0" pads, and short them together. Then you need a ST-Link and follow the instructions for the First time flashing method 2. Don't forget to remove the solder bridge on the Boot0 pads when you are done.