Hi guys. So, I have been messing around with my FPGA board, slowly learning verilog, and currently, I am working on designing a "simplistic" cpu. It does work, it can read instructions and execute them, it has a fairly decent amount of instructions implemented. However, just now, I tried to change a few things and all of the sudden, whenever I compile, it just says 0 LE's. So its not compiling the processor or any of the other stuff (pll, ram, etc). All I tried to do was change a register name and size... and add a few instructions. Im wondering if there is some way I can see what the issue is or if I have to figure it out myself. The warnings dont seem to have anything to do with it, but im not sure...