Attiny85 development board not recognised by Windows 10

[YurkshireLad]

I have what I think must be a Digispark Attiny85 development board. I've followed the instructions from the following site and other sites:

https://www.best-microcontroller-projects.com/digispark-attiny85-arduino-install.html

When I connect the dev board to any USB port on my Windows 10 laptop, an error pops up saying the device isn't recognised.

I installed the drivers from https://github.com/digistump/DigistumpArduino/releases/ but that didn't change anything.

I tried all USB ports on my laptop, USB2 and USB3, but all give the same errors.

Did I miss anything? Is there something else I need to install?

Thanks

[rpiloverbd]

Hello, here is a video and blog that may help you
https://startingelectronics.org/tutorials/arduino/digispark/digispark-windows-setup/
if you have not checked it yet.

[YurkshireLad]

Thank.

"After the driver installation has finished, click the Finish button in the Device Driver Installation dialog box."

I don't recall seeing this dialog so maybe the drivers didn't install properly.