Electronics > Microcontrollers

USB Type C interfacing with STM32F7


I need to connect the data pins of USB and STM32 so that I can program the microcontroller in DFU mode. I am using a Type C USB port (requested by the customer) and I am finding it difficult to figure out a way to interface it. Should I connect the two sets of differential pair pins of the USB together and use them?


This is a common question. You can refer to this thread as well: https://www.eevblog.com/forum/projects/usb-type-c-(usb2-0)-wiring/


[0] Message Index

There was an error while thanking
Go to full version