Electronics > Open Source Hardware

OSHW pic18f4550 based arduino

(1/3) > >>

SixD:
I was planning to do pic18f4550 based arduino. i have tested pinguino but i don't get it to work.

westfw:
See "USB Bit Whacker"
But it might be easier to figure out what went wrong with your pinguino...

SixD:
I checked it out but it was for pic18f2550. The pic18f4550 has more I/O.

adam1213:

--- Quote from: SixD on December 15, 2013, 06:19:14 pm ---I was planning to do pic18f4550 based arduino. i have tested pinguino but i don't get it to work.

--- End quote ---

What doesn't work? e.g.
* You can't install the software
* The software does not compile
* After programming the bootloader on to the device you can't program the device
* You can compile programs and program the device through the bootloader however the programs do not run as expected


--- Quote from: SixD on December 16, 2013, 06:44:01 pm ---I checked it out but it was for pic18f2550. The pic18f4550 has more I/O.

--- End quote ---
The pic18f2550 and pic18f4550 share the same datasheet and are BOTH supported by pinguino. e.g. http://wiki.pinguino.cc/index.php/PIC18F4550_Pinguino

SixD:
The problem with pinguino is that I can't upload software to the board via pinguino ide.

Navigation

[0] Message Index

[#] Next page