STLINK-V3MINIE adapter to 2.54mm pinheader - OSHW

[DerTobi]

I thought this might be the right place to publish this project and also a good opportunity to introduce myself to the forum I built a small adapter PCB which adds a standard pitch pin header to the inexpensive STLINK-V3MINIE. There is also a current limited LDO supply for the target included. I hope this might be helpful for some of the STM32 fans here.

You can find all files and some details how to built it on https://www.embedded-ideas.de/posts/250214_stlink-v3minie_adapter/

[coromonadalix]

you where too late  loll  dang  that's what i needed 

i had to patch my minie   almost like yours,

I soldered an idc header and bending theses pins to fit the minie spacing  and get the 5v  or you have a 3.3v reg on it  loll and use dupont jumpers ...

kudos for your board   

[DerTobi]

Thank you. It's good to know that it would have been useful I had this in my drawer for quite a while now but didn't had the time to write a blog post. Maybe next time I do a quik'n'dirty pre-release.