Electronics > Open Source Hardware

µSupply in SMD

(1/2) > >>

Dileptor:
Hi,

this is my first post and I'm fairly new to the site so just let me say that the EEVblog is brilliant! The world needs more people like Dave.

Now, I was wondering if the µSupply project could be converted to a SMD version. The reason I want to do that is that I have to design a
PCB for a school project (Czech Technical University). It can be anything I like only the size must be 5cm*10cm at most. And by the looks of
it the TH version looks larger. So what do you think? Could it be done? Or should I not waste my time trying ?

Martin

shebu18:
The ySupply is now a smd version. It would be hard to fit in into a 5x10cm board.

Dileptor:
Really? As far as I know there are about 12 videos about the power supply project and it's all through hole design.
Where did you find that it's smd ?
Thanks

firewalker:
Dave mentioned it a couple of times. Don;t if it was on a video or on a thread.

Alexander.

PedroDiogo:
Today Dave posted a video clearly showing the new µSupply is using SMD.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version