EEVblog > Other Blogs

Ben Heck's Show Oscilloscope Watch

(1/2) > >>

miguelvp:
Not sure I would wear a watch scope probing a pinball cabinet.



I mean, I like what he does in general but this looks a bit dangerous and no disclaimers are stated.

And a 200 KHz scope?

The manual should say to at least keep your other hand on the back pocket, and gabotronics for some reason are developing a scope watch as well:

http://www.gabotronics.com/



voltlog:
Well, the tiny oscilloscopes were already on the market so it was only a matter of time before people start strapping them to their hands  :D
Is it dangerous? It depends on what you do with it. Measuring some logic or even analog signals from your 5V rails can't be that dangerous.
BTW, according to their specs these tiny scopes have an Input Voltage Range: -14V to +20V so you can't really probe anything dangerous.

dexters_lab:
it's quite impractical and not likely to be used in anger but would make a great novelty present for the right geek

pickle9000:
Mr. Heck is more of a graphic artist / case designer, and he does very well with that. I don't watch the show often but it's seems well produced and educational.

crispy_tofu:

--- Quote from: pickle9000 on October 14, 2015, 09:31:40 pm ---Mr. Heck is more of a graphic artist / case designer, and he does very well with that. I don't watch the show often but it's seems well produced and educational.

--- End quote ---

Watched the video and the case design is fantastic!
I don't wish to derail the thread, but the way he says 'solder' in my opinion is slightly painful. America!  ;)

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod