Author Topic: Latest version of DasmX?  (Read 1084 times)

0 Members and 1 Guest are viewing this topic.

Offline metertech58761Topic starter

  • Frequent Contributor
  • **
  • Posts: 271
  • Country: us
Latest version of DasmX?
« on: May 12, 2025, 08:21:02 pm »
Is there a newer version of DASMx than 1.40 (from the GeoCities archive)?

It has a bad bug in that it fails to properly calculate the target address when disassembling relative mode instructions in 68HC05 code.
(attached ZIP contains the executable, docs, and one of the three files I want to convert back to source)

The only other option besides DASMx is IDA Pro, which is unjustifiably expensive for my purposes ($40, $50, sure - but a $365/year subscription? for 3 files? Yeah, no.) :(
« Last Edit: May 12, 2025, 08:23:36 pm by metertech58761 »
 

Offline PA0PBZ

  • Super Contributor
  • ***
  • Posts: 5519
  • Country: nl
Re: Latest version of DasmX?
« Reply #1 on: May 13, 2025, 09:16:39 am »
Give Ghidra a try, it's free, supports 6805 and can do pseudo C which (imo) reads easier than assembly.
Keyboard error: Press F1 to continue.
 

Offline metertech58761Topic starter

  • Frequent Contributor
  • **
  • Posts: 271
  • Country: us
Re: Latest version of DasmX?
« Reply #2 on: May 14, 2025, 11:48:01 am »
I have tried Ghidra in the past, but it didn't like something in my Windows setup. I'll have to try again later.

I did figure out the issue with DASMx... the 6805 mode was apparently built around the 6805P2, which has a 2K address space (cutoff at 07FF) while I was working with code written for the 68HC05C9A which uses 16K of address space.

I also got the disassembly I needed on another forum.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 

- - -
-->