Electronics > Projects, Designs, and Technical Stuff
14.4V ground reference for ADC
<< < (32/33) > >>
Arjunan M R:

--- Quote from: Simon on June 02, 2019, 09:09:50 am ---a crude solution could be a resistor. To stop the resistor drawing a lot of power at higher voltages you can use comparators that switch in and out different resistors.

--- End quote ---
The problem with resistors are that i will get false readings in m current measurement.If it is a constant current  source or circuit i can just subtract the current of the constant current source.
Simon:
Well you are shoehorning one thing on top of another. If this was designed properly it would not be a problem. The current sense could come after all of the regulation with the feedback being taken from the final output.
Arjunan M R:
Okay, i will not worry about the current measurement.
Is there any way to constantly sink 1mA to a opamp?
Simon:
There probably is but i can't be bothered right now.
Arjunan M R:

--- Quote from: Simon on June 02, 2019, 10:14:09 am ---There probably is but i can't be bothered right now.

--- End quote ---
I will try to make it myself.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod