Electronics > Projects, Designs, and Technical Stuff

14.4V ground reference for ADC

<< < (33/33)

Simon:
that would be a good idea.  Something along the lines of driving a BJT powering a resistor from the output while sensing the voltage across the resistor to keep the voltage constant.

Arjunan M R:
MADE IT!!!! :)
What it does is subtract 100mV(1mA x 100Ω = 100mV) from the output voltage of the regulator.And feeds it into the other side of the resistor.So that the current flowing through the resistor is always 1mA.
The opamp used in the real circuit will be lm358.
In the simulation it can work below even 500mV.
I will build it using lm358 and test it out, i think it will work in lower than 1V.

Here is the circuit (image)↓↓↓↓

Arjunan M R:
Here is the simulation in LTspice
Edit:Added buffered input to the differential amplifier and added the voltage divider.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod