Electronics > Projects, Designs, and Technical Stuff
14.4V ground reference for ADC
<< < (20/33) > >>
Arjunan M R:
So i think i will stick with this voltage reference.
Arjunan M R:

--- Quote from: Simon on May 30, 2019, 06:37:16 am ---Your reference outputs 10mA, I doubt any DAC input wants moro than that. read carefully any notes about the output capacitor value and type required.

--- End quote ---
REF 3120 does not require a output bypass capacitor.Only a supply bypass of more than 0.47µF.
I am going to still add a 10µF tantulum and 100nF ceramic cap to input and output for extra stability and noise reduction.
Arjunan M R:
IT requires a 100nF cap. for supply bypass.
Simon:
Yes just follow the datasheets recomendations. You are drawing µA not mA so you don't need to go heavy handed on the output capacitance. Filtering it is not a bad idea.
Arjunan M R:

--- Quote from: Simon on May 30, 2019, 11:47:50 am ---Yes just follow the datasheets recomendations. You are drawing µA not mA so you don't need to go heavy handed on the output capacitance. Filtering it is not a bad idea.

--- End quote ---
So i will put only a 100nF bypass cap at the output.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod