Electronics > Projects, Designs, and Technical Stuff

14.4V ground reference for ADC

<< < (20/33) > >>

Arjunan M R:
So i think i will stick with this voltage reference.

Arjunan M R:

--- Quote from: Simon on May 30, 2019, 06:37:16 am ---Your reference outputs 10mA, I doubt any DAC input wants moro than that. read carefully any notes about the output capacitor value and type required.

--- End quote ---
REF 3120 does not require a output bypass capacitor.Only a supply bypass of more than 0.47µF.
I am going to still add a 10µF tantulum and 100nF ceramic cap to input and output for extra stability and noise reduction.

Arjunan M R:
IT requires a 100nF cap. for supply bypass.

Simon:
Yes just follow the datasheets recomendations. You are drawing µA not mA so you don't need to go heavy handed on the output capacitance. Filtering it is not a bad idea.

Arjunan M R:

--- Quote from: Simon on May 30, 2019, 11:47:50 am ---Yes just follow the datasheets recomendations. You are drawing µA not mA so you don't need to go heavy handed on the output capacitance. Filtering it is not a bad idea.

--- End quote ---
So i will put only a 100nF bypass cap at the output.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod